TM 9-2320-269-20-1
THERMOSTATS
This task covers:
a. Removal (page 2-237)
c. Testing (page 2-240)
b. Cleaning (page 2-240)
d. Installation (page 2-241)
INITIAL SETUP:
Tools
Materials/Parts
Extension, 3/8-inch drive, 6-inch
Gasket, water outlet
Hammer, hand, rubber
Lockwasher, alternator bracket
Handle, hinged, 3/8-inch drive
Lockwasher, water outlet (four required)
Handle, ratchet, 3/8-inch drive
Rags, wiping (item 24, appendix C)
Pan, drain
Solvent, drycleaning, (item 28, appendix C)
Scraper, gasket
Thermostat, (two required if needed)
Screwdriver, flat-tip, 3/8-inch
Socket, 3/8-inch drive,
Personnel Required
9/16-inch
Thermometer
One
Wrench, box-end, 9/16-inch
Wrench, open-end, 112-inch
Equipment Condition
Wrench, open-end, 11/16-inch
(two required)
Hoods raised (page 2-7).
Wrench, torque, 3/8-inch drive,
Battery cable disconnected (page 2-414).
0-200 in-lb capacity
Cooling system drained (page 2-265).
2-236
Previous Page
