TM 9-2320-269-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE - CONTINUED
CRANKS BUT WILL NOT START - CONTINUED
Step 9.
Inspect neutral lockout switch (1) and wires (2) for corrosion and damage.
a. Remove engine cover (3) and transmission cover (4) (page 2-840).
b. Disconnect wires (2) and (5).
c.
If wires (5) are corroded or damaged, clean or repair (page 2-142) as needed.
d. If wires (2) are corroded or damaged, clean or replace switch as needed.
Step 10.
Test neutral lockout switch (1) for resistance.
a. Connect ohmmeter to wires (2), check reading with transmission in neutral, and disconnect.
b. If meter reads more than zero ohms resistance, replace switch (1) using two 9/16-inch and
7/8-inch wrenches. c. Connect wires (2) and (5), and install transmission cover (4) and engine
cover (3) using flat-tip screwdriver.
TA228578
2-50
Previous Page
