FENDERS - CONTINUED
INSTALLATION - CONTINUED
Drycleaning solvent burns easily. Do not smoke or have open flame nearby when using solvent. Dispose
of solvent-soaked rags properly. If brush is used, clean properly.
Fender (1) and
Using drycleaning solvent and rags,
immediately wipe off extra sealer.
side panel (2)
32. Access cover (3)
Put in place, and hold.
33. Access cover (3)
Two screws (4)
Screw in, and tighten using cross-tip
to fender (1)
34. Parking light (5)
Pull back through splash panel (7), and
put plug into light (5).
35. Junction block (8)
Step 36 applies to left front fender only.
36. Two winch
Screw (11), two
a. Put clips (12) over hoses (10).
hoses (10) to
clips (12), and
b. Put screw (11) through front side of
c. Screw on nut (13), and tighten using
7116-inch socket and handle.