PRIMARY AIR RESERVOIR - CONTINUED
REMOVAL - CONTINUED
Lift off brackets (2) and (3).
If reservoir is being removed for access to other components, go to INSTALLATION.
Mark location of fitting before removal to aid in installation.
Using 1 1/16-inch wrench, unscrew
and take off.
If reservoir was removed for access to other components, go to step 8.
Install fitting in original position to insure proper hookup of lines.
Wipe clean, and wrap with two turns
Screw in, and tighten using 1 1/16-
Put in with fitting (4) facing forward.
(2) and (3)
Two cables (5)
Put cables (5) in.
and four nuts (6)
Screw on nuts (6), and tighten using
9/16-inch deep well socket, extension,
handle, and pliers wrench.