STOPLIGHT SWITCH - CONTINUED
REMOVAL - CONTINUED
1. Four studs (1)
Four nuts (2) and
a. Unscrew, and take off using
2. Two rails (4)
3. Two terminals (6)
Two nuts (7),
Using 3/8-inch wrench, unscrew and
and lead wires (9)
Drain air from system before removing lines or fittings to avoid personnel injury from compressed air.
4. Elbow (10)
Using 5/8-inch and 11/16-inch
wrenches, unscrew and take off.
5. Elbow (12)
Using two 3/4-inch wrenches, unscrew
and take off.
Mark position of elbows on switch before removal to aid in installation.
6. Pipe (14)
Using 1-inch wrench and pipe wrench, un-
screw and take off.
7. Switch (15)
Unscrew, and take off using 11/16-inch
Unscrew, and take off using 3/4-inch