PROPELLER SHAFTS AND UNIVERSAL JOINTS - CONTINUED
INSTALLATION - CONTINUED
Two universal joint
a. Place cap (5) into yoke upper finger
yoke (2) and
(6), and tap sharply into place with
mating yoke (11)
(4) and (5)
hammer and wood block.
b. Place cap (4) into yoke lower finger
(7), and tap sharply into place with
hammer and wood block, evenly guiding
universal cross (3) into bearing
caps (4) and (5).
Two locking plates
a. Put locking plates (8) onto yoke (2)
(8) and four
b. Screw in, and tighten screws (9)
using 9/16-inch socket and handle.
Check all parts for tightness and alignment.
Lubricate all parts (LO 9-2320-269-12).
TASK ENDS HERE