ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
TEST OR INSPECTION
ELECTRICAL SYSTEM - CONTINUED
24-VOLT CONVERTER NOT WORKING
Remove seat back (6) using 9/16-inch wrench.
Check fuses (7), and replace as needed.
Check ground wire (8) for corrosion and damage.
If wire terminals (9) are corroded or damaged, remove wire (8) using flat-tip screwdriver, 7/16-inch
socket, handle, and 7/16-inch wrench. Clean, or replace (page 2-142) as needed.
b. If wire (8) is corroded or damaged, replace or repair (page 2-142) as needed.