TM 11-5895-1081-40P/E2137-BV-PLL-040/5103 TS3853/TO 31S5-2G-234
4. Special Information
Z -Nonreparable item. When unserviceable, condemn
a. The following publication pertains to the TS-
and dispose at the level indicated in position 3.
3853/G and its components: TM 11-5895-1081-14, Test
H -Reparable item. When uneconomically reparable,
Set, Telephone TS-3853/G (To be published)
condemn and dispose at the general support level.
b. National stock numbers (NSN's) that are
D-Reparable item. When beyond lower level repair
capability, return to depot. Condemnation and
Electronics Command and Fort Monmouth, ATTN:
disposal not authorized below depot level.
DRSEL-ME-MM, Fort Monmouth, NJ 07703 fr the par
c. National Stock Number. Indicates the National
required to support your equipment.
stock number assigned to the item and will be used for
5. How to Locate Repair Parts
d. Federal Supply Code for Manufacturer
(FSCM). The FSCM is a 5-digt numeric code listed in SB
a. When National stock number or part number
708-4142 which is used to identify the manufacturer,
distributor, or Government agency, etc.
(1) First. Using the table of contents, determine
e. Part Number. Indicates the primary number
the functional group within which the item belongs. This
used by the manufacturer (individual, company, firm,
is necessary since illustrations are prepared fr functional
corporation, or Government activity), which controls the
groups and listings are divided into the same groups.
design and characteristics of the item by means of its
(2) Second. Find the illustration covering the
engineering drawings, specifications, standards, and
functional group to which the item belongs. (3) Third.
inspection requirements to identify an item or range of
Identify the item on the illustration and note the
illustration figure and item number of the item.
(4) Fourth. Using the Repair Parts Listing find
the figure and item number noted on the illustration.
b. When National stock number or part number
When a stock numbered item is requisitioned, the repair
part received may have a different part number than the
(1) First. Using the Index of National Stock
part being replaced.
Numbers and Part Numbers, find the pertinent National
f. Description. Indicates the Federal item name
stock number or part number. This index is in NIIN
and, if required, a minimum description to identify the
sequence followed by a list of part numbers in
alphameric sequence, cross-referenced to the illustration
g. Unit of Measure (UIM). Indicates the standard
figure number and item number.
of the basic quantity of the listed item as used in
(2) Second. After finding the figure and item
performing the actual maintenance function. This
number, locate the figure and item number in the repair
measure is expressed by a two-character alphabetical
abbreviation (e.g., ea, in, pr, etc). When the unit of
measure differs from the unit of issue, the lowest unit of
issue that will satisfy the required units of measure will
h. Quantity Incorporated in Unit. Indicates the
quantity of the item used in the breakout shown on the
illustration figure, which is prepared for a functional
group, subfunctional group, or an assembly.
(Next printed page is 4)